Paste Residence Time in a Spouted Bed Dryer. II: Effect of Spout Operational Conditions

Residence time distributions for an aqueous solution of 10% sodium chloride in a spouted bed dryer of inert particles were determined using the stimulus-response technique. Glass and polyethylene beads with diameters 2.6 and 3.4 mm were used as inert bodies in a cylindrical column of 14.0 cm diameter and 60° conical base. The effects of inert bodies load, air, and paste flow rates on the mean residence times and RTD were determined following 2³ factorial designs. The RTD could be correlated to the perfect mixing cell model with R² varying from 0.8684 to 0.9815. The mean residence times in CSBD varied from 10.8 to 13.9 and 10.7 to 13.3 min for glass and polyethylene beads, respectively. For both inert particles, mean residence times increased with bed height and decreased with paste feed rates. Also, terms of interaction among the factors were significant in some cases, showing a complex behavior of paste residence times. Equations obtained by response surface regression could predict mean residence times on glass and polyethylene beads with deviations lower than ±10%.     

冷凝器中弓形折流板结构与两相流诱发的振动

根据两相流体诱发振动的机理与相关公式,对在两相流状态下运行的稀醋酸酐冷凝器进行了振动分析,结果表明,采用双弓形折流板可有效地防止换热器的振动。     

爆炸箔起爆系统初始电阻对爆发电流和飞片速度影响的数值模拟

研究了电爆炸箔起爆系统起爆回路初始电阻对爆发电流和冲击片雷管飞片速度的影响规律，分析了影响电爆炸箔起爆系统体系的因素，为在可靠发火条件下降低起爆系统体积提供设计参考。     

Non-Steady Equilibrium during Pro-Eutectoid Ferrite Formation in Fe-0.2C Alloy

Ｔｈｅｐｒｅｃｉｐｉｔａｔｉｏｎｏｆｐｒｏ ｅｕｔｅｃｔｏｉｄｆｅｒｒｉｔｅｆｒｏｍａｕｓｔｅｎｉｔｅｉｓｃｏｎｔｒｏｌｌｅｄｂｙｄｉｆｆｕｓｉｏｎｉｎＦｅ Ｃａｌｌｏｙｓ .Ｗｉｔｈｔｈｅａｓｓｕｍｐｔｉｏｎｔｈａｔｔｈｅｍｉｇｒａｔｉｎｇｉｎｔｅｒｆａｃｅｉｓａｌｗａｙｓｉｎｌｏｃａｌｅｑｕｉｌｉｂｒｉｕｍ ,ｅａｒｌｙｉｎ 194 9,ＺｅｎｅｒＣ[1] ｅｘｐｌａｉｎｅｄｔｈｅｄｉｆｆｕｓｉｏｎａｌｇｒｏｗｔｈｏｆｐｒｏ ｅｕｔｅｃ ｔｏｉｄｆｅｒｒｉｔｅｂｙｕｓｉｎｇｔｈｅＦｉｃｋ’ｓｌａｗ .Ｓｉｎｃｅ…     

固液相变蓄能的数学模型和自然对流换热系数的实验研究

引入自然对流换热系数 ,将固液蓄能数学模型简化为仅用能量方程加以描述。并通过实验测得相变过程的实际温度场 ,证明了自然对流固液相变换热的影响不可忽略 ,验证了固液相变界面移动速率随自然对流换热系数的增大而增大的定性关系     

DRYING OF GRANULAR PARTICLES IN A MULTISTAGE INCLINED FLUIDIZED BED WITH MECHANICAL VIBRATION

A mathematical model for the drying rate of granular particles in a multistage inclined fluidized bed(IFB) is presented from the standpoint of simultaneous heat and mass transfer, with taking the effect of mechanical vibration added vertically into consideration.

Steady-state distributions for the temperatures and concentrations of the particles and the heating gas, and for the moisture content of the particles are numerically calculated based on the present model. The calculated results show fairly good agreement with the experimental data, which were obtained from the drying experiments of brick particles in a three-stage IFB using comparatively low temperature air(40-60°C) as the heating gas.

It has been found within the range of the experimental conditions employed that, the mechanical vibration added vertically enhances the over-all drying rate of the particles and its effect can be considered equivalent to an increase in the air velocity.     

VTI介质中弹性参数地震反演方法

根据地震波在具有垂直对称轴的横向各向同性（VTI）介质中的运动学特征，应用传播时间反演方法，进行了水平层状VTI介质的地层弹性参数反演方法研究。在VTI介质中，P－P波的传播时间曲线不再是双曲线，尤其在长排列情况下，已不能用二项泰勒展式精确地反演P－P波的传播时间，用三项泰勒展式则可以达到更高精度；P－SV波的传播时间也可用三项泰勒展式表达，在中等及短排列长度时可达到一定精神。对P－P波、P－SV波的传播时间进行三项泰勒展开时，它们的系数中包含了地震波的各向异性信息及垂直速度信息，中以为地震波的弹性参数反演提供提供基础，模试验分析及江苏油田某地区的二维多波资料实际反演结果表明，在最大炮间距为1．5倍地层埋深时，可以很精确地得到三项泰勒展式的系数，应用这些系数能精确反演地层弹性参数，包括P波、S波的垂直速度和各向异性参数。图4表1参5（杜丽英摘）     

核电厂管系振动鉴定

本文介绍了核电厂管道振动鉴定概况,讨论了目前使用的管系振动的鉴定方法,给出了鉴定准则。     

100m高烟囱拆除爆破冲击振动测试与分析

在新乡电厂百米钢筋混凝土烟囱爆破拆除工程中,布置了不同方向的两条测线共9个测点,量测了爆破和烟囱倒塌触地引起的地面质点振速和主振频率。从实测数据的分析认识到:烟囱顶部落地产生的冲击力最大,线状震源正前方测点的振速比其侧向测点的振速要大;烟囱倒塌触地产生的振动是各段筒体所产生的振动的叠加,它与各分段体的质量、位置高度、材质强度等因素有关;高大建(构)筑物落地冲击地振动的频率一般比爆破引起的地振动的频率要低;铺设缓冲材料、分段爆破等措施可减小触地冲击引起的地面振动强度。此外,利用实测数据进行拟合,得出了适用于描述本工程烟囱倒塌触地冲击地振动衰减规律的经验公式。     

Mechanical and thermal properties of HVOF sprayed Ni based alloys with carbide

The objective of the present study is to develop multi-functioned coating to the components, which are made of copper with electroplated Ni and are widely used for steel making industry. In this paper, we report the mechanical and thermal properties of Ni based superalloys with carbide sprayed by high velocity oxygen fuel (HVOF), and the detailed effects of sprayed material, spraying conditions, and initial powder structure on these properties. It was found that, among commercial Ni self-fluxing alloys (without fusing treatment), coating with a carbon content of 0.58 mass% had the most preferable properties, with a good balance of the hardness, strength, and thermal shock resistance. The thermal shock resistance depended not only on the strength of the coating but also on the volume contraction when tested at high temperatures. For the several developed Ni based superalloys with carbide, Ni20Cr8Mo5Fe–WC and Ni16Cr15Mo3–WC demonstrated the prominent adhesion strength and thermal shock resistance with high Galvanic corrosion resistance through optimized spraying condition. Also, 20 mass% NiCr–Cr₃C₂ coating sprayed by using employed relatively small primary particle succeeded in achieving the multi-superior properties; high adhesion strength, high corrosion resistance and thermal shock resistance.